In the process of using maintenance?

A. Use in the process of maintenance

1. Before use to install the shaft for cleaning. And check whether installed shaft has a bruised, dirt, if any shall all be cleared away.

2. The use of the reducer is 0 ~ 40 ℃ temperature.

3. Check with the hole or shaft of reducer connection with size is in accordance with the requirements of the hole of tolerance should be H7 tolerance for H6 (axis).

4. Before use should be the highest level of congestion vent plug, ensure reduction during exhaust gas in the body.

2. The installation of speed reducer

1. The reducer can only be installed on the flat, vibration and torsional support structure.

2. In any case, are not allowed to use a hammer to pulley, coupling, small gear or sprocket and type on the output shaft, and that this might damage the bearing axis.

3. Use and maintenance

1. Reducer after installation, check whether the flexible. Please must be formally used for no-load test, in the case of normal operation, in the loading operation step by step.

2. The reducer is used by more than the rated load is strictly prohibited.

3. The reducer before use and check the oil level is normal work.

4. In oil system:

The first oil change the machine run 300 ~ 400 hours after a lubricating oil should be replaced, replace lubricating oil every 1500 ~ 2000 hours later. In poor working conditions, high temperature, high dust big should work situation every half a month to a check of lubricating oil, found dirt or replace lubricating oil, lubricating oil to keep the oil clean and extend the service life of reducer, improve the economic benefit.

Replacing oil change to wait five. Oil reducer cooled down without burning dangerous, but should still keep warm, because completely cooled, the oil viscosity increase, oil drain.